Exterior Lighting System Halogen type
Side turn signal lamp
In this manual: Exterior Lighting System Halogen type
~1min read
Exploded View

1. Side turn signal lamp bulb 2. Side turn signal lamp hous
Removal and Installation
CAUTION:Disconnect battery negative terminal or remove the fuse.
REMOVAL
1. Remove the side turn signal lamp in numerical order shown in the figure.2. Rotate the bulb socket counterclockwise and unlock it.
NOTE:
Support side turn signal lamp harness with tape so that it won't fall into the front fender.
: Vehicle front (side turn
signal lamp LH)
: Vehicle rear (side turn signal
lamp RH)

INSTALLATION
1. Rotate the bulb socket clockwise and lock it.2. Fix the pawl-side behind the side turn signal lamp housing first, then push the resin clip-side.
Replacement
CAUTION:• Disconnect the battery negative terminal or the fuse. • Never touch the glass of bulb directly by hand. Keep grease and other oily matters away from it. • Never touch bulb by hand while it is lit or right after being turned off.
• Never leave bulb out of lamp reflector for a long time because dust, moisture smoke, etc. may affect the performance of lamp. When replacing bulb, be sure to replace it with new one
.
SIDE TURN SIGNAL LAMP BULB
1. Remove side turn signal lamp. Refer to EXL-98, "Removal and Installation".2. Remove bulb from the bulb socket.
Was this page helpful?