Additional Service When Replacing Around View Monitor Control Unit
BEFORE REPLACEMENT
When replacing around view monitor control unit, save or print current vehicle specification with CONSULT configuration before replacement.
AFTER REPLACEMENT
Complete the procedure of “After Replace ECU” in order.
If you set incorrect “After Replace ECU”, incidents might occur.
Configuration is different for each Nissan Murano vehicle model. Confirm configuration of each vehicle model.
SAVING VEHICLE SPECIFICATION
CONSULT
Enter “Re/Programming, Configuration” and perform “Before Replace ECU” to save or print current Nissan Murano vehicle specification.
>>GO TO 2.
REPLACE AROUND VIEW MONITOR CONTROL UNIT
Replace around view monitor control unit. Refer to Removal and Installation.
>>GO TO 3.
WRITING Nissan Murano Vehicle SPECIFICATION
CONSULT
Enter "Re/Programming, Configuration".
If “Before Replace ECU” operation was performed, automatically an "Operation Log Selection" screen will be displayed. Select the applicable file from the "Saved Data List" and press “Confirm” to write Nissan Murano vehicle specification. Refer to Work Procedure.
If “Before Replace ECU” operation was not performed, select "After Replace ECU" or "Manual Configuration" to write Nissan Murano vehicle specification. Refer to Work Procedure.
GO TO 4.
OPERATION CHECK
Check that the operation of the around view monitor control unit and camera images (fixed guide lines and predictive course lines) are normal.
>>Work End.