Engine

Additional Service When Replacing Ecm

7steps
~42min
3/5difficulty
Done 0 of 7
Description

When replacing ECM, the following procedure must be performed. (For details, refer to Work Procedure.)

PROGRAMMING OPERATION

Work Procedure

Work Procedure (Before Replacing ECM)

SAVE ECM DATA

With CONSULT

  1. Turn ignition switch OFF.

  2. Reconnect all harness connectors disconnected.

  3. Turn ignition switch ON.

  4. Select “SAVING DATA FOR REPLC CPU” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.

  5. Follow the instruction of CONSULT display.

>>

GO TO 2.

SAVE ‘OPERATION LOG’

With CONSULT

Save Operation Log, according to the procedure of “Programming” in CONSULT Operation Manual.

>>
  • Replace ECM.

  • After replacing ECM, perform necessary work.

Work Procedure (After Replacing ECM)

CHECK ‘OPERATION LOG’

With CONSULT

Check Operation Log saved before replacing ECM, according to the procedure of “Programming” in CONSULT Operation Manual.

Is there an applicable Operation Log in the Saved Data List?

YES>>

GO TO 2.

NO>>

GO TO 3.

PERFORM ECM PROGRAMMING

With CONSULT

Perform ECM programming, according to “Programming” of CONSULT Operation Manual. Refer to CONSULT Operation Manual.

  • Ignition switch: ON

  • Electric load: OFF

  • Brake pedal: Not depressed

  • Battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

>>

GO TO 5.

READ IN ECM PART NUMBER BY ‘FAST LINKED’

Obtain ECM part number by NISSAN PARTS CATALOGUE GLOBAL Web-FAST, according to the procedure of ‘FAST linked’ in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

>>

GO TO 4.

PERFORM PROGRAMMING (FAST LINKED)

With CONSULT

Perform ECM programming according to the procedure of FAST linked in CONSULT Operation Manual. Refer to CONSULT Operation Manual.

  • Ignition switch: ON

  • Electric load: OFF

  • Brake pedal: Not depressed

  • Battery voltage: 12 – 13.5 V (Check the value displayed on the CONSULT screen.)

>>

GO TO 5.

PERFORM INITIALIZATION OF IVIS (NATS) SYSTEM AND REGISTRATION OF ALL IVIS (NATS) IGNITION KEY IDS

Refer to Work Procedure.

>>

GO TO 6.

CHECK ECM DATA STATUS

Check if the data is successfully copied from the ECM at Step 1 (before replacement) and saved in CONSULT.

Is the data saved successfully?

YES>>

GO TO 7.

NO>>

GO TO 8.

WRITE ECM DATA

With CONSULT

  1. Select “WRITING DATA FOR REPLC CPU” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.

  2. Follow the instruction of CONSULT display.

>>

GO TO 9.

PERFORM VIN REGISTRATION

Refer to Description.

>>

GO TO 9.

PERFORM ACCELERATOR PEDAL RELEASED POSITION LEARNING

Refer to Description.

>>

GO TO 10.

PERFORM THROTTLE VALVE CLOSED POSITION LEARNING

Refer to Description.

>>

GO TO 11.

PERFORM IDLE AIR VOLUME LEARNING

Refer to Description.

>>

END