Driver Information & Multimedia

B1360 Combination Meter

8steps
~48min
2/5difficulty
Done 0 of 8
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B1360–02

Combination meter

(Combination meter connection error)
Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

  • AV communication circuit is open

  • Combination meter

FAIL-SAFE

Steering switch is inoperative

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Ignition switch OFF and wait at least 30 seconds.

  3. Ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “MULTI AV”.

  5. Check DTC.

Is DTC B1360 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

CHECK COMBINATION METER POWER SUPPLY AND GROUND CIRCUIT

Check combination meter power supply and ground circuit. Refer to DTC Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning parts.

CHECK AV COMMUNICATION CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect AV control unit connector and combination meter connector.

  3. Check the continuity between AV control unit connector and combination meter connector.

    AV control unitCombination meterContinuity
    ConnectorTerminalConnectorTerminal
    M162 22 M23 50 Yes
    23
    42 49
    43

Is the inspection result normal?

YES>>

Replace combination meter. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning parts.