Driver Information & Multimedia
Power Supply and Ground Circuit. Av Control Unit
In this manual: Driver Information & Multimedia
5steps
~30min
2/5difficulty
Done 0 of 5
CHECK FUSE
Check that the following fuses are not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 7 | ACC power supply | 7 | 10 A |
| 17 | Ignition power supply | 29 | 10 A |
| 19 | Battery power supply | 15 | 20 A |
Are the fuses blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect AV control unit connectors.
Check voltage between AV control unit connectors and ground.
AV control unit Ground Condition Voltage
(Approx.)Connector Terminal M161 19 — Ignition switch: OFF Battery voltage 7 Ignition switch: ON 17
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Ignition switch OFF.
Check continuity between AV control unit connector and ground.
AV control unit Ground Continuity Connector Terminal M161 20 — Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?