B2098 Ign Relay on Circ
IPDM E/R operates the ignition relay-1 when it receives an ignition switch ON signal from BCM via CAN communication.
Turn the ignition relay-1 OFF by pressing the push-button ignition switch once when the Nissan Murano vehicle speed is 4 km/h or less.
Turn the ignition relay-1 OFF with the following operation when the Nissan Murano vehicle speed is more than 4 km/h or when an abnormal condition occurs in CAN communication from the combination meter (Emergency OFF)
Press and hold the push-button ignition switch for 2 seconds or more.
Press the push-button ignition switch 3 times within 1.5 seconds.
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| B2098 | IGN RELAY ON CIRC (Ignition relay ON circuit) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | – | ||
| Threshold | – | ||
| Diagnosis delay time | 1 second or more | ||
Possible Cause
IPDM E/R.
Harness or connectors (ignition relay-1 circuit short).
FAIL-SAFE
Turns ON the tail lamp relay for 10 minutes.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Ignition switch OFF and wait 1 second or more.
Select “Self Diagnostic Result” mode of “IPDM E/R”.
Check DTC.
Is DTC detected?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
SELF DIAGNOSTIC RESULT
CONSULT
Select “Self Diagnostic Result” mode of “IPDM E/R”.
What is the display history of DTC “B2098”?
“CRNT”>>GO TO 2.
“PAST”>>GO TO 5.
CHECK IGNITION RELAY-1 CONTROL CIRCUIT VOLTAGE 1
Ignition switch ON.
Check voltage between IPDM E/R harness connector and ground.
(+) (–) Voltage
(Approx.)IPDM E/R Connector Terminal E119 43 Ground 0 V
Is the inspection result normal?
YES>>GO TO 4.
NO>>GO TO 3.
CHECK IGNITION RELAY-1 CONTROL CIRCUIT VOLTAGE 2
Ignition switch OFF.
Disconnect IPDM E/R connector and BCM connector M19.
Ignition switch ON.
Check voltage between IPDM E/R harness connector and ground.
(+) (–) Voltage
(Approx.)IPDM E/R Connector Terminal E119 43 Ground 0 V
Is the inspection result normal?
YES>>Replace IPDM E/R. Refer to Removal and Installation.
NO>>Repair or replace harness.
CHECK IGNITION RELAY-1 CONTROL CIRCUIT
Ignition switch OFF.
Disconnect IPDM E/R connector.
Check continuity between IPDM E/R harness connector and ground.
IPDM E/R Ground Continuity Connector Terminal E119 43 No
Is the inspection result normal?
YES>>Perform the diagnosis procedure for DTC B26F2. Refer to DTC Description.
NO>>Repair or replace harness.
CHECK INTERMITTENT INCIDENT
Refer to Intermittent Incident.
>>Inspection End.