Electrical & Power Control

B2099 Ign Relay Off Circ

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B2099

IGN RELAY OFF CIRC

(Ignition relay OFF circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal) IPDM E/R circuit (Terminal 43)
Threshold Less than 8.8V
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • IPDM E/R

  • Fuse

  • Battery

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “IPDM E/R”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK FUSE

Check that all of the fuses installed on the downstream of the contact point side circuit of the ignition relay-1 in IPDM E/R are not blown.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Replace the blown fuse after replacing the affected circuit if a fuse is blown.

CHECK IGNITION RELAY-1 CONTROL CIRCUIT VOLTAGE

  1. Ignition switch ON

  2. Check voltage between IPDM E/R harness connector and ground.

    (+)(–)

    Voltage

    (Approx.)
    IPDM E/R
    ConnectorTerminal
    E119 43 Ground 0 V

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace IPDM E/R. Refer to Removal and Installation.

CHECK BATTERY VOLTAGE

Check battery voltage.

Which is the measurement result?

More than 12.4 V>>

GO TO 4.

Less than 12.4 V>>

Perform battery inspection. Refer to How to Handle Battery.

CHECK INTERMITTENT INCIDENT

Refer to Intermittent Incident.

>>

Inspection End.