Electrical & Power Control
U1010 Control Unit(can)
In this manual: Electrical & Power Control
3steps
~18min
2/5difficulty
Done 0 of 3
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC Detection Condition | |
|---|---|---|---|
| U1010 | CONTROL UNIT(CAN) (Control unit CAN) |
Diagnosis condition | When ignition switch ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
IPDM E/R
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON and wait for 2 seconds or more.
Select “Self Diagnostic Result” mode of “IPDM E/R”.
Check DTC.
Is DTC displayed?
YES>>Refer to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
REPLACE IPDM E/R
Replace IPDM E/R. Refer to Removal and Installation.
>>Inspection End.
Was this page helpful?