Cruise Control & Driver Assistance

Blind Spot Warning

6steps
~36min
4/5difficulty
Done 0 of 6
Description

Always perform the Blind Spot Warning system action test to check that the system operates normally after replacing the side radar LH/RH, or repairing any Blind Spot Warning system malfunction.

  • Precautions: Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service.

  • System description for Blind Spot Warning: Refer to System Description.

  • Normal operating condition: Refer to Description.

Work Procedure
  • Precautions: Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service.

  • System description for Blind Spot Warning: Refer to System Description.

  • Normal operating condition: Refer to Description.

CHECK BSW SYSTEM SETTING

  1. Start the engine.

  2. Check that the BSW system setting can be enabled/disabled on the integral switch.

  3. Turn OFF the ignition switch and wait for 5 seconds or more.

  4. Check that the previous setting is saved when the engine starts again.

>>

GO TO 2.

BSW SYSTEM ACTION TEST

  1. Enable the setting of the BSW system on the integral switch.

  2. Check BSW operation according to the following table:

    Nissan Murano Vehicle condition/ Driver's operationAction

    Nissan Murano Vehicle speed

    (Approx.)
    Turn signal conditionStatus of Nissan Murano vehicle detection within detection area

    Indication on the

    Blind Spot Warning indicator
    Indication on the combination meterIndicator colorBuzzer

    Less than approx.

    29 km/h
    — — OFF ON White OFF

    Approx.

    32 km/h

    or more
    — Nissan Murano Vehicle is absent OFF ON White OFF
    OFF Nissan Murano Vehicle is detected ON ON White OFF

    ON

    (Nissan Murano vehicle detected direction)

    Before turn signal operates

    Vehicle is detected
    Blink Blink Yellow (Blink) Short continuous beeps
    Nissan Murano Vehicle is detected after turn signal operates Blink Blink Yellow (Blink) OFF
>>

Inspection End.