Cruise Control & Driver Assistance

Rcta

6steps
~36min
4/5difficulty
Done 0 of 6
Description

Always perform the RCTA system action test to check that the system operates normally after replacing the side radar LH/RH, or repairing any BSW/RCTA system malfunction.

  • Precautions: Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service.

  • System description for RCTA: Refer to System Description.

  • Normal operating condition: Refer to Description.

Work Procedure
  • Precautions: Refer to Blind Spot Warning/Rear Cross Traffic Alert (RCTA) System Service.

  • System description for RCTA: Refer to System Description.

  • Normal operating condition: Refer to Description.

CHECK BSW/RCTA SYSTEM SETTING

  1. Start the engine.

  2. Check that the BSW system setting can be enabled/disabled on the integral switch.

  3. Turn OFF the ignition switch and wait for 30 seconds or more.

  4. Check that the previous setting is saved when the engine starts again.

>>

GO TO 2.

ACTION TEST FOR RCTA

  1. Enable the setting of the RCTA system on the integral switch.

  2. Check the RCTA operation according to the following table:

    Nissan Murano Vehicle conditionActionBuzzer
    • R range

    • 8 km/h

    If the radar detects an approaching Nissan Murano vehicle from the side.
    • Chime sound (single beep)

    • Flashes Blind Spot Warning indicator on the side of the approaching Nissan Murano vehicle is detected.

    • Yellow rectangular frame appears in the display.

    Single beep
    No approaching Nissan Murano vehicle No action —
>>

Inspection End.