Brake Caliper Assembly

| 1. | Torque member | 2. | Bushing | 3. | Piston boot |
| 4. | Slide pin boot | 5. | Slide pin | 6. | Piston |
| 7. | Piston seal | 8. | Brake caliper body | 9. | Brake hose |
| 10. | Copper sealing washers | 11. | Bleeder cap | 12. | Inner shim cover |
| 13. | Inner shim | 14. | Inner pad | 15. | Pad retainer |
| 16. | Anti-rattle clip | 17. | Outer pad | 18. | Outer shim |
| 19. | Outer shim cover | A. | Nigrove Rx-2 | B. | Rubber grease |
| C. | Molykote® AS-880N | ||||
REMOVAL
Remove reservoir cap from the reservoir tank.
Remove front wheels and tires using power tool.
Secure the disc brake rotor using wheel nuts.
Remove union bolt, copper sealing washers, and disconnect brake hose from brake caliper. Discard the copper sealing washers.
Remove slide pin bolts and the brake caliper.

Remove the brake pads from the torque member.
INSTALLATION
Install the brake pads in the torque member.
Position the brake caliper to torque member and install the slide pin bolts. Tighten to specification.
Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose and install it as an assembly to the brake caliper. Align the brake hose L-pin by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.

Refill with new brake fluid and perform the air bleeding. Refer to Bleeding Brake System.
Install the front wheels and tires. Refer to Removal and Installation.
INSPECTION AFTER INSTALLATION
Check the drag of front disc brake. If any drag is found, follow the procedure described below.
Remove brake pads.
Using a suitable tool, press the pistons into the brake caliper body.
Install brake pads.
Depress the brake pedal several times.
Check the drag of front disc brake again. If any drag is found, disassemble the brake caliper body.
Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Pedal.