Brake Pad

| 1. | Torque member | 2. | Bushing | 3. | Piston boot |
| 4. | Slide pin boot | 5. | Slide pin | 6. | Piston |
| 7. | Piston seal | 8. | Brake caliper body | 9. | Brake hose |
| 10. | Copper sealing washers | 11. | Bleeder cap | 12. | Inner shim cover |
| 13. | Inner shim | 14. | Inner pad | 15. | Pad retainer |
| 16. | Anti-rattle clip | 17. | Outer pad | 18. | Outer shim |
| 19. | Outer shim cover | A. | Nigrove Rx-2 | B. | Rubber grease |
| C. | Molykote® AS-880N | ||||
REMOVAL
Observe brake fluid level in the sub tank. Partially drain brake fluid if necessary. Refer to Drain and Refill.
Remove the front wheels and tires using power tool.
Remove slide pin bolts.
Remove the brake caliper from the torque member. Leaving brake hose attached, reposition the brake caliper aside with wire.
Remove the brake pads, shims, shim covers, pad retainers, and anti-rattle clips from the torque member.
Compress the front caliper pistons.
INSTALLATION
Install the new pad retainers and anti-rattle clips to the torque member.
Apply Molykote® AS-880N grease to the mating faces between the inner shim, inner shim cover, outer shim and outer shim cover and install them to the brake pad. Refer to Exploded View.
Install the brake pads to the torque member.
Using a suitable tool, press the pistons into the brake caliper.
Install the brake caliper to the torque member.
Install the slide pin bolts and tighten to specification. Refer to Exploded View.
Depress the brake pedal several times and verify that drag does not exist.
Install the front wheels and tires. Refer to Removal and Installation.
Check brake fluid level and refill as necessary. Refer to Inspection.
INSPECTION AFTER INSTALLATION
Check the drag of front disc brake. If any drag is found, follow the procedure described below.
Remove brake pads.
Using a suitable tool, press the pistons into the brake caliper body.
Install brake pads.
Depress the brake pedal several times.
Check the drag of front disc brake again. If any drag is found, disassemble the brake caliper body.
Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Pedal.