Brakes

Brake Caliper Assembly

~3min read
Exploded View
1. Torque member 2. Bushing 3. Piston boot
4. Slide pin boot 5. Slide pin 6. Piston
7. Piston seal 8. Brake caliper body 9. Bleeder cap
10. Brake hose 11. Copper sealing washers 12. Inner shim cover
13. Inner shim 14. Inner pad 15. Pad retainer
16. Outer pad 17. Outer shim 18. Outer shim cover
A. Niglube Rx-2 B. Rubber grease C. Molykote® AS-880N
: Apply brake fluid.
Removal and Installation

REMOVAL

Remove reservoir cap from the reservoir tank.

Remove rear wheels and tires using power tool.

Secure the disc brake rotor using wheel nuts.

Remove union bolt, copper sealing washers, and disconnect brake hose from brake caliper. Discard the copper sealing washers.

Remove the torque member bolts. Remove the brake caliper and torque member from the Nissan Murano vehicle as an assembly.

Remove the brake pads from the torque member.

Remove the slide pin bolts and the brake caliper from the torque member.

INSTALLATION

Install the brake pads to the torque member.

Install the brake caliper to torque member and install the slide pin bolts. Tighten to specification.

Install the brake caliper and torque member to the Nissan Murano vehicle as an assembly. Install the torque member bolts.

Assemble the union bolt (A) and the copper sealing washers (1) to the brake hose and install it as an assembly to the brake caliper. Align the brake hose L-pin by aligning it with the brake caliper hole, and tighten the union bolt (1) to the specified torque.

Refill with new brake fluid and perform the air bleeding. Refer to Bleeding Brake System.

Install the rear wheels and tires. Refer to Removal and Installation.

INSPECTION AFTER INSTALLATION

Check the drag of rear disc brake. If any drag is found, follow the procedure described below.

Remove brake pads.

Using a suitable tool, press the pistons into the brake caliper body.

Install brake pads.

Depress the brake pedal several times.

Check the drag of rear disc brake again. If any drag is found, disassemble the brake caliper body.

Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Pedal.