Brakes

Brake Pad

~3min read
Exploded View
1. Torque member 2. Bushing 3. Piston boot
4. Slide pin boot 5. Slide pin 6. Piston
7. Piston seal 8. Brake caliper body 9. Bleeder cap
10. Brake hose 11. Copper sealing washers 12. Inner shim cover
13. Inner shim 14. Inner pad 15. Pad retainer
16. Outer pad 17. Outer shim 18. Outer shim cover
A. Niglube Rx-2 B. Rubber grease C. Molykote® AS-880N
: Apply brake fluid.
Removal and Installation

REMOVAL

Observe brake fluid level in sub tank. Partially drain brake fluid if necessary. Refer to Drain and Refill.

Remove the rear wheels and tires using power tool.

Loosen the lower slide pin bolt and remove the upper slide pin bolt.

Using the lower slide pin bolt as a pivot, swing the brake caliper down from the torque member. Leaving the brake hose attached, support the brake caliper with wire.

Remove the brake pads, shims, shim covers, and pad retainers from the torque member.

Compress the rear caliper piston.

INSTALLATION

Install the new pad retainers to the torque member.

Apply Molykote® AS-880N grease to the mating faces between the brake pads and the pad retainers. Refer to Exploded View.

Apply Molykote® AS-880N grease to the mating faces between the brake pads, inner shim (1) and outer shim (2). Install components to the brake pad. Refer to Exploded View.

Install the brake pads to the torque member.

Using a suitable tool, press the piston into the brake caliper.

Using the lower slide pin bolt as a pivot, swing the brake caliper up to the torque member.

Install the upper slide pin bolts. Tighten all slide pin bolts to specification. Refer to Exploded View.

Depress the brake pedal several times and verify that drag does not exist.

Install the front wheels and tires. Refer to Removal and Installation.

Check brake fluid level and refill as necessary. Refer to Inspection.

INSPECTION AFTER INSTALLATION

Check the drag of rear disc brake. If any drag is found, follow the procedure described below.

Remove brake pads.

Using a suitable tool, press the piston into the brake caliper body.

Install brake pads.

Depress the brake pedal several times.

Check the drag of rear disc brake again. If any drag is found, disassemble the brake caliper body.

Burnish contact surfaces after refinishing or replacing disc brake rotors or if a soft pedal occurs at very low mileage. Refer to Brake Pedal.