Ventilation, Heater & Air Conditioner

Compressor

~1min read
0204060801005541N·mlb·ft
Tightening torque found on this page
Removal and Installation

REMOVAL

Discharge the refrigerant. Refer to Recycle Refrigerant.

Partially remove the front edge of the front fender protector (RH). Refer to Removal and Installation.

Remove the bolts that retain the oil cooler line brackets to the engine block and reposition the oil cooler line aside. Refer to Removal and Installation.

Remove the drive belt. Refer to Removal and Installation.

Disconnect the harness connector from the compressor.

Disconnect the low-pressure flexible hose from the compressor.

Disconnect the high-pressure flexible hose from the compressor.

Remove the compressor bolts then remove the compressor.

INSTALLATION

Installation is in the reverse order of removal.

Bolts (1,2) : 55 N·m
Bolts (3,4) : 61 N·m