Transmission & Driveline

Front Wheel Hub

~2min read
Exploded View
1. Cotter pin 2. Nut retainer 3. Disc brake rotor
4. Wheel hub and bearing 5. Wheel stud 6. Splash guard
7. Steering knuckle Front
Removal and Installation

REMOVAL

Remove disc brake rotor. Refer to Removal and Installation.

Remove wheel sensor bolt (A) and position wheel sensor aside. Refer to Exploded View.

Remove cotter pin.

Remove nut retainer.

Loosen wheel hub lock nut from drive shaft using power tool.

Using a piece of wood and a suitable tool, tap on wheel hub lock nut to disengage drive shaft from wheel hub and bearing.

Remove wheel hub lock nut.

Remove wheel hub and bearing bolts using power tool.

Remove splash guard and wheel hub and bearing from steering knuckle.

If necessary, remove wheel studs (1) using a suitable tool (A).

INSPECTION AFTER REMOVAL

Check components for deformation, cracks, and other damage. Replace if necessary.

INSTALLATION

Installation is in reverse order of the removal.

  • Place a washer (A) as shown to install wheel studs (1) by using tightening force of nut (B).

  • Clean mating surfaces of wheel hub lock nut and wheel hub and bearing.

  • Hold wheel hub and bearing using a suitable tool. Tighten wheel hub lock nut.

  • When installing cotter pin (1) and nut retainer (2), securely bend cotter pin to prevent rattles.