Electrical & Power Control

Main Line Between Ipdm-E and Abs Circuit

4steps
~24min
2/5difficulty
Done 0 of 4
Diagnosis Procedure

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect the following harness connectors.

    • ECM

    • IPDM E/R

    • ABS actuator and electric unit (control unit)

  4. Check the continuity between the IPDM E/R harness connector and the ABS actuator and electric unit (control unit) harness connector.

    IPDM E/R harness connector

    ABS actuator and electric unit (control unit)

    harness connector
    Continuity
    Connector No. Terminal No. Connector No. Terminal No.
    E119 29 E125 26 Existed
    28 14 Existed

Is the inspection result normal?

YES>>

Check CAN system type decision again.

YES>>

Error was detected in the main line between the IPDM E/R and the ABS actuator and electric unit (control unit).

NO>>

Repair the main line between the IPDM E/R and the ABS actuator and electric unit (control unit).