Electrical & Power Control

Vehicle Can Communication Circuit

11steps
~66min
3/5difficulty
Done 0 of 11
Diagnosis Procedure

CONNECTOR INSPECTION

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect all the unit connectors on Nissan Murano vehicle CAN communication system.

  4. Check terminals and connectors for damage, bend and loose connection.

Is the inspection result normal?

YES>>

GO TO 2

NO>>

Repair the terminal and connector.

CHECK HARNESS CONTINUITY (OPEN CIRCUIT)

Check the continuity between the 3CH CAN gateway harness connector terminals and power steering control module harness connector terminals.

3CH CAN gateway harness connector Power steering control module harness connector Continuity
Connector No. Terminal No. Connector No. Terminal No.
M5 1 E62 8 Existed
2 7 Existed

Is the inspection result normal?

YES>>

GO TO 3

NO>>

Check the harness and repair the root cause.

CHECK HARNESS CONTINUITY (SHORT CIRCUIT)

Check the continuity between the 3CH CAN gateway harness connector terminals.

3CH CAN gateway Continuity
Connector No. Terminal No.
M5 1 2 Not existed

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Check the harness and repair the root cause.

CHECK HARNESS CONTINUITY (SHORT CIRCUIT)

Check the continuity between the 3CH CAN gateway harness connector terminal and the ground.

3CH CAN gateway Ground Continuity
Connector No. Terminal No.
M5 1 Not existed
2 Not existed

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Check the harness and repair the root cause.

CHECK ECM AND IPDM E/R TERMINATION CIRCUIT

  1. Remove the ECM and the BCM.

  2. Check the resistance between the ECM terminals.

    ECM Resistance (Ω)
    Terminal No.
    124 123 Approx. 108 – 132
  3. Check the resistance between the BCM terminals.

    BCM Resistance (Ω)
    Terminal No.
    60 59 Approx. 108 – 132

Is the measurement value within the specification?

YES>>

GO TO 6.

NO>>

Replace the ECM and/or the BCM.

CHECK SYMPTOM

Connect all the connectors. Check if the symptoms described in the “Symptom (Results from interview with customer)” are reproduced.

Inspection result

Reproduced>>

GO TO 7.

NO>>

Start the diagnosis again. Follow the trouble diagnosis procedure when past error is detected.

CHECK UNIT REPRODUCTION

Perform the reproduction test as per the following procedure for each unit.

  1. Turn the ignition switch OFF.

  2. Disconnect the battery cable from the negative terminal.

  3. Disconnect one of the unit connectors of Nissan Murano vehicle CAN communication system.

  4. Connect the battery cable to the negative terminal. Check if the symptoms described in the “Symptom (Results from interview with customer)” are reproduced.

Inspection result

Reproduced>>

Connect the connector. Check other units as per the above procedure.

NO>>

Replace the unit whose connector was disconnected.