Body Interior
Memory Storing
In this manual: Body Interior
2steps
~12min
1/5difficulty
Done 0 of 2
Always perform the memory storage when the battery terminal is disconnected or the driver seat control unit is replaced. The memory function will not operate normally if no memory storage is performed.
Memory Storage Procedure
Two positions for the driver seat, steering column and outside mirror can be stored for memory operation by the following procedure:
STEP 1
Check the following conditions:
Ignition switch: ON
CVT shift selector: P (Park) position
GO TO 2.
STEP 2
Adjust driver seat, steering column and outside mirror position manually.
>>GO TO 3.
STEP 3
Push set switch.
Push the memory switch (1 or 2) for at least 1 second within 5 seconds after pushing the set switch.
GO TO 4.
STEP 4
Confirm the operation of each part with memory operation.
>>Inspection End.
Was this page helpful?