Body Interior

System Setting

3steps
~18min
2/5difficulty
Done 0 of 3
Description

The settings of the automatic drive positioner system can be changed using CONSULT, the display unit in the center of the instrument panel and the set switch. Always check the settings before and after disconnecting the battery terminal or replacing driver seat control unit.

Setting Change

×: Applicable

ItemContentCONSULTSet switchFactory setting

Amount of seat sliding for

entry/exit assist

The amount of seat sliding for entry/exit assist can be selected from 3 items.

[40 mm/80 mm/150 mm]
x — 40 mm

Entry/exit assist

(seat)

Entry/exit assist (seat) can be selected:

ON (operated) – OFF (not operated)
x x ON

Entry/exit assist

(steering column)

Entry/exit assist (steering column) can be selected:

ON (operated) – OFF (not operated)
x ON
Work Procedure

CHOOSE METHOD

There are two setting methods.

Which method do you choose?

With CONSULT>>

GO TO 2.

With set switch>>

GO TO 4.

WITH CONSULT - STEP 1

CONSULT

Select “Work support” mode of “AUTO DRIVE POS.”.

>>

GO TO 3.

WITH CONSULT - STEP 2

CONSULT

  1. Select the “EXIT SEAT SLIDE SETTING” or “EXIT TILT SETTING” in “Work support” mode of “AUTO DRIVE POS.”, then touch display to change between ON and OFF.

    • EXIT SEAT SLIDE SETTING: Entry/exit assist (seat)

    • EXIT TILT SETTING: Entry/exit assist (steering column)

  2. Select the “SEAT SLIDE VOLUME SET” in “Work support” mode of “AUTO DRIVE POS.” and touch either “40 mm”, “80 mm”, or “150 mm”.

  3. Then touch “OK”.

>>

Inspection End.

WITH SET SWITCH - STEP 1

Ignition switch OFF.

>>

GO TO 5.

WITH SET SWITCH - STEP 2

Push set switch and hold for more than 10 seconds then confirm blinking of the memory switch indicator.

  • Entry/exit assist (seat/steering column) is ON: Memory switch indicator blinks two times.

  • Entry/exit assist (seat/steering column) is OFF: Memory switch indicator blinks once.

>>

Inspection End.