Driver Controls
Rear Combination Lamp (back Door Side)
In this manual: Driver Controls
~1min read

| 1. | Rear combination lamp (back door side) | A. | Harness connector | Metal stud | |
| Clip |
REMOVAL
Remove back door lower finisher. Refer to Removal and Installation.
Remove rear combination lamp (back door side) nuts.
Disconnect harness connector, pull rear combination lamp (back door side) rearward and remove.
INSTALLATION
Installation is in the reverse order of removal.
TAIL LAMP BULB
The tail lamp bulb is LED and not serviced separately. Refer to Removal and Installation.
BACK-UP LAMP BULB
The-back up lamp bulb is LED and not serviced separately. Refer to Removal and Installation.
Was this page helpful?