Driver Controls
Rear Washer Nozzle
In this manual: Driver Controls
~1min read
REMOVAL
Remove the rear spoiler. Refer to Removal and Installation.
Disconect the rear washer tube from the rear washer nozzle.
Remove the rear washer nozzle bolt and remove the rear washer nozzle.
INSTALLATION
Installation is in the reverse order of removal.
INSPECTION
Check that air can pass through the nozzle by blowing into the nozzle, and check that air cannot flow in the opposite direction.

If operating properly, the spray positions should match the position shown. If spray position does not match, confirm the rear washer nozzle is properly seated and working properly. If the spray position still does not match as shown, then replace the rear washer nozzle. Refer to Removal and Installation.

| 1. | Black print | 2. | Spray target area | 3. | Back door glass |
| 4. | Wiper area | A. | Center line | B. | 7.0 mm (0.28 in) |
| C. | 21.7 mm (0.85 in) | D. | 34.6 mm (1.36 in) | E. | 9.9 mm (0.39 in) |
Was this page helpful?