Electrical & Power Control
S Terminal Circuit
In this manual: Electrical & Power Control
2steps
~12min
1/5difficulty
Done 0 of 2
CHECK “S” TERMINAL CONNECTION
Ignition switch OFF.
Check if “S” terminal is clean and tight.
Is the inspection result normal?
YES>>GO TO 2.
NO>>Repair “S” terminal connection. Confirm repair by performing system test using 165-DSS-5000P. Refer to the applicable Instruction Manual for proper testing procedures.
CHECK “S” TERMINAL CIRCUIT
Check voltage between generator harness connector and ground.
| (+) | (—) | Voltage (Approx.) | |
|---|---|---|---|
| Generator | |||
| Connector | Terminal | ||
| F7 | 3 | Ground | Battery voltage |
Is the inspection result normal?
YES>>Refer to Work Flow (With 165-DSS-5000P), or (Without 165-DSS-5000P).
NO>>Check harness for open between generator and fuse.
Was this page helpful?