Restraints

Spiral Cable

~3min read
Exploded View
1. Spiral cable 2. Steering angle sensor A. Spiral cable screws
B. Steering angle sensor screws C. Locating pin
Removal and Installation

REMOVAL

Disconnect negative and positive battery terminals, then wait at least three minutes. Refer to Removal and Installation.

Remove steering wheel. Refer to Removal and Installation.

Remove steering column upper and lower covers. Refer to Removal and Installation.

Disconnect harness connectors (A) from spiral cable and harness connector (B) from steering angle sensor.

Remove screws (A) then release pawls and remove spiral cable and steering angle sensor (1) as an assembly.

: Pawl

Remove screws (A) then release pawls (B) and separate steering angle sensor (2) from spiral cable (1).

INSTALLATION

Installation is in the reverse order of removal.

  • The turn signal lever must be in the neutral position for spiral cable installation.

  • Set the spiral cable neutral position by carefully turning the spiral cable clockwise to the end position. Turn the spiral cable counterclockwise 2.5 turns stopping when the locating pin (A) is at the top most position, the triangles (C) are pointing at each other as shown and the clear window (B) appears white.

  • During steering wheel installation, make sure the locating pin hole (D) is aligned with the locating pin (A) of the spiral cable.

  • Perform the neutral position adjustment for the steering angle sensor. Refer to Description.