Heating programming

This function allows you to schedule the start of heating on vehicles without a range extender.

Heating energy is drawn from the electricity distribution network via the charging socket.

The vehicle must therefore be connected to the electricity distribution network.

Programming:

• Set control D toor, depending on the vehicle, press the on-board computer scroll control 1.
• Turn the ignition key to A (accessories).
• Turn air temperature control button B until the heating indicator light stays onon the instrument panel.

You must set the time to elapse before the heating starts.

The on-board computer displays the previous setting.

To cancel the previous setting, press the on-board computer memory reset button 2.

To set the heating start delay, press the display selection button 1.

• Each short press increases the time by 15 minutes.
• Each long press (more than 2 seconds) increases the time by one hour.

To confirm your selection, wait about five seconds without pressing buttons 1 and 2.

The setting is confirmed when OK appears on the display.

You can remove the key once the screen has switched off.

The heating will run for one and a half hours.

Heating indicator lightflashes on the instrument panel.

• You can schedule the heating start up to 5 days in advance.

• Heating can only start once charging is complete (heating indicator light steady green).
• When the heating starts, the heating indicator light flashes.
• You can check the time remaining before heating starts by setting the ignition key to A (accessories) and pressing scroll button 1.

Note: to return to the normal display, set control D to .