Renault Kangoo Quiz
Electrical equipment

Vertical aim adjustment

In this manual: Electrical equipment
Renault Kangoo Driver's Manual — 100Mechanisms and accessories — 44Mechanisms and Accessories — 7Diagnostic — 61Bodywork — 85Electrical equipment — 31Engine and peripherals — 88Bodywork — 24Chassis — 56Renault Kangoo 2 Electric Owner's Manual — 21Transmission — 14Air conditioning — 26General vehicle information — 24Sealing and soundproofing — 1Trim and upholstery — 1
~1min read

REMOVAL - REFITTING OF THE CONTROL

Réglage en site

Remove the coin tray or the switch holder depending on version, then reach inside the dashboard to unclip the control and push it outwards.

WIRING

Refer to the Technical Note "Wiring diagrams".

REMOVAL - REFITTING OF THE RECEIVER

Disconnect the connector from the vertical aim adjustment receiver.

Réglage en site

Turn the receiver an eighth of a turn towards the centre of the vehicle to release it from the headlamp.

Then disengage the receiver ball joint and the headlamp reflector to remove the receiver.

REFITTING NOTES

Remove the protective cover from the lamp connectors at the rear of the headlamp unit.

Hold the reflector towards the rear of the headlamp by pulling on the lamp bases, and snap the ball joint into its dedicated housing.

Then reposition the receiver on the headlamp by turning it an eighth of a turn.

Reconnect the connector and refit the protective cover on the lamps at the rear of the headlamp.

Set the vertical aim control to "0" and adjust the headlamp:

  • screw (G) for height adjustment,

  • screw (F) for direction adjustment.

Test yourself

A quick Renault Kangoo quiz: every answer comes with an explanation and a link to the manual page.