Renault Megane Quiz
Electrical equipment

Rear height sensor

In this manual: Electrical equipment
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~1min read

Tightening torques
rear height sensor fixing screw 8 N.m

REMOVAL

Capteur de hauteur arrière
Capteur de hauteur arrière
  • Remove:
  • the clip (1),
  • the fixing screw (2) of the rear height sensor.

INSTALLATION

  • Position the sensor with its bracket on the vehicle.
  • Tighten the rear height sensor fixing screw to torque (8 N.m).

WARNING: Always replace the clip (1) after each removal.

Note:
  • The rear sensor does not have the same electronic characteristics as the front sensor, so it is very important not to swap them.
  • The rear sensor has a green colour marking.
  • Always perform an initialisation of the xenon lamp system (Chapter Xenon Lamps, Xenon Headlamps: Adjustment, page 80C-14) and adjust the headlamps.

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.