Renault Megane Quiz
Engine and peripherals

Configurations - learning

In this manual: Engine and peripherals
Engine and peripherals — 141Chassis — 79Chassis — 72Renault Mégane III Driver's Manual — 87Electrical equipment — 221Engine and peripherals — 47Electrical equipment — 80Transmission — 14Air conditioning — 30Bodywork — 115Trim and upholstery — 44General vehicle information — 27Air conditioning — 59General vehicle information — 16Transmission — 38Sealing and soundproofing — 7General vehicle information — 3
~1min read

PARAMETERS:

  • VP001: Injector code, cylinder 1.
  • VP002: Injector code, cylinder 2.
  • VP003: Injector code, cylinder 3.
  • VP004: Injector code, cylinder 4.

    These commands allow manual entry of the calibration code printed on the injector.

    Use these commands after replacing an injector, after replacing or (re)programming the ECU, when command SC001 does not work.

  • VP010: VIN writing.

    This command allows manual entry of the vehicle VIN into the ECU. Use this command after each ECU replacement or (re)programming.

SPECIFIC COMMANDS:

  • SC001: Writing saved data.

    Use this command after replacing or (re)programming the ECU (if the data was saved using SC003).

  • SC002: Injector code entry.

    This command allows manual entry of the calibration code printed on the injectors.

    Perform this command after replacing the injectors.

  • SC003: ECU data backup.

    This command saves the ECU operating data, the C2I parameters (individual injector correction) and the engine adaptives. Perform this command before replacing or (re)programming the ECU.

OTHER COMMANDS:

  • LC005: Gearbox type.

    This command shows the gearbox type configured on the vehicle.

Test yourself

A quick Renault Megane quiz: every answer comes with an explanation and a link to the manual page.