Floor Console Assembly Repair Procedures

Replacement

Wear gloves to protect your hands.

When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage. Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the shift lever knob and boot (A) by pulling them upward.

   

2. 2
   Remove the tray (B) using the remover holder hole, after removing the rubber mat (A).

   

3. 3
   Using a screwdriver or remover, remove the front console upper cover (A).

   

4. 4
   Disconnect the connectors (A).

   

5. 5
   Remove the console armrest (A).

   

6. 6
   Remove the storage box garnish (A).

   

7. 7
   Loosen the mounting screws and bolts, then remove the rear console assembly (A).

   

8. 8
   Disconnect the multimedia jack connectors (A).

   

9. 9
   Loosen the mounting screws, then remove the front console assembly (A).

   

10. 10
    Install in the reverse order of removal.

    Make sure the connector is properly connected. Replace any damaged clips.