Power Window Motor Repair Procedures

Inspection

Wrap the screwdriver or puller tool with protective tape. Handle with care during storage and during disassembly/assembly, as it is easily contaminated by grease and oil. Be careful not to scratch the door trim and other parts.

1. 1
   Disconnect the negative (-) battery terminal.
2. 2
   Remove the front door trim panel. (Refer to Body - "Front Door Trim")
3. 3
   Disconnect the motor connector from the motor.

   

4. 4
   Connect terminals No. 1 and No. 2 to battery voltage (12 V) and check that the motor operates smoothly when connected as shown below. [Safety Window Motor]

   

5. 5
   Connect the motor terminals directly to battery voltage (12 V) and check that the motor operates smoothly. Then reverse the polarity and check that the motor operates smoothly in the opposite direction. If operation is abnormal, replace the motor. [Standard Power Window]

   

6. 6
   Disconnect the negative (-) battery terminal.
7. 7
   Remove the rear door trim panel. (Refer to Body - "Rear Door Trim")
8. 8
   Disconnect the motor connector from the motor.

   

9. 9
   Connect motor terminals No. 1 and No. 2 directly to battery voltage (12 V) and check that the motor operates smoothly. If operation is abnormal, replace the motor. [Safety Window Motor]