Hyundai Sonata LF Quiz
Engine Mechanical System

Rear Oil Seal Repair Procedures

In this manual: Engine Mechanical System
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
8steps
~58min
4/5difficulty
2special tools
Done 0 of 8

Removal

  1. Remove the transaxle assembly. (Refer to Transaxle - Manual Transaxle Assembly, Automatic Transaxle Assembly)
  2. MT: Remove the flywheel. (Refer to Cylinder Block - "Flywheel")
  3. AT: Remove the drive plate. (Refer to Cylinder Block - "Drive Plate")
  4. Remove the rear oil seal (A).

Installation

  1. Install the rear oil seal.
    1. Apply engine oil to the lip of the new oil seal.
    2. Using SST (09231-H1100, 09231-2B200) and a hammer, drive in the rear oil seal until its surface is flush with the rear oil seal retainer edge.
  2. MT: Install the flywheel. (Refer to Cylinder Block - "Flywheel")
  3. AT: Install the drive plate. (Refer to Cylinder Block - "Drive Plate")
  4. Install the transaxle assembly. (Refer to Transaxle - Manual Transaxle Assembly, Automatic Transaxle Assembly)

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.