Hyundai Sonata LF Quiz
Body (Interior and Exterior)

Trunk Lid Assembly Repair Procedures

In this manual: Body (Interior and Exterior)
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
4steps
~24min
2/5difficulty
010203040508.86N·mlb·ft
Tightening torque found on this page
Done 0 of 4

Replacement
  • Wear gloves to protect your hands from injury.
  • An assistant is required to remove and install the trunk lid.
  1. Remove the trunk lid trim. (Refer to Trunk Lid - "Trunk Lid Trim")
  2. Disconnect the trunk lid connectors and wiring harness (A).
  3. After removing the bolts, remove the trunk lid assembly (B).

    Tightening torque: 6.9 ~ 8.8 N·m

  4. Install in the reverse order of removal.
    • Make sure the trunk lid latches/unlatches and opens/closes properly.
    • Adjust the liftgate alignment.
    • Make sure the connectors are connected correctly.
    • Replace all damaged clips.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.