Heated oxygen sensor (ho2s) removal and installation

• be careful not to expose the ho2 sensor to excessive shock.
• Do not use an impact wrench when removing or installing the ho2 sensor.
• Be careful not to twist or damage the ho2 sensor lead wires.

1. 1
   Lift and support the fuel tank with the prop stay.

   Refer to “fuel tank removal and installation” in section 1g .

2. 2
   Disconnect the ho2 sensor coupler (1).

   

3. Remove the ho2 sensor (2).

Install the ho2 sensor in the reverse order of removal.

Pay attention to the following points:

Caution do not apply oil or other materials to the sensor air hole.

• Tighten the ho2 sensor to the specified torque.

Refer to “dtc “c44” (p0130/p0135): ho2 sensor (ho2s) circuit malfunction” in section 1a (page 1a- 103).