Rear wheel dust seal / bearing removal and installation

1. 1
   Remove the rear wheel assembly. Refer to “rear wheel assembly removal and installation” .
2. 2
   Remove the rear sprocket mounting drum assembly (1) from the rear wheel.

   

3. Remove the wheel dampers (2).

4. Remove the dust seal.

Special tool (a): 09913–50121 (oil seal
remover)

5. Remove the bearings on both sides using the special tool.

Special tool (b): 09921–20240 (bearing remover
set)

6. Remove the spacer (3).

Caution the removed dust seal and bearings must be replaced with new ones.

1. Apply grease to the wheel bearings.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

2. First install the right wheel bearing, then install the spacer (1) and left wheel bearing with the special tools.

Special tool (a): 09941–34513 (bearing
installer) (b): 09924–84510 (bearing
installer set)

Caution the sealed cover of the bearing must face outside.

Spacer Clearance

1. Install new dust seal with the special tool.

Special tool (c): 09913–70210 (bearing
installing set (10 – 75 Ф))

1. 1
   Install the rear sprocket mounting drum assembly (2).
2. 2
   Apply grease to the lip of dust seals.

: Grease 99000–25010 (suzuki
super grease “a” or equivalent)

6. Install the rear wheel assembly. Refer to “rear wheel assembly removal and installation” .