Regulated voltage inspection

Inspect the regulated voltage in the following procedures:

1. 1
   remove the front seat. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).
2. 2
   Start the engine and keep it running at 5 000 r/min with the dimmer switch turned hi position.
3. 3
   Measure the dc voltage between the battery (+) and (–) terminals using the multi-circuit tester. If the voltage is not within the specified value, inspect the generator and regulator/rectifier. Refer to “generator inspection” and “regulator / rectifier inspection” .

when making this test, be sure that the battery is in fully charged condition.

Special tool (a): 09900–25008 (multi circuit
tester set)

Tester knob indication voltage ( )

4. Install the front seat. Refer to “exterior parts removal and installation” in section 9d (page 9d- 6).