Use of sds diagnosis reset procedures

the malfunction code is memorized in the ecm also when the lead wire coupler of any sensor is disconnected. Therefore, when a lead wire coupler has been disconnected at the time of diagnosis, erase the stored malfunction history code using sds.

1. 1
   After repairing the trouble, turn off the ignition switch and turn on again.
2. 2
   Click the dtc inspection button (1).

   

1. 1
   Check the dtc.
2. 2
   The previous malfunction history code (past dtc) still remains stored in the ecm. Therefore, erase the history code memorized in the ecm using sds tool.
3. 3
   Click “clear” (2) to delete history code (past dtc).

   

1. Follow the displayed instructions.

7. Check that both “current dtc” (3) and “past dtc” (4) are deleted (nil).

1. 1
   Close the sds tool and turn the ignition switch off.
2. 2
   Disconnect the sds tool and install the front seat.