Toyota 4Runner Quiz
Vehicle Exterior

Glass Position Initialization Incomplete (B2313)

In this manual: Vehicle Exterior
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
~2min read
DESCRIPTION

The power window regulator motor is driven by operating the power window switch. The power window regulator motor assembly has a motor and ECU.

When the ECU determines that the power window regulator motor has not been initialized, DTC B2313 is stored.

HINT:

This DTC may be stored for all the windows.

NOTICE:

  • When a power window regulator motor is reinstalled or replaced, the power window control system must be initialized.
  • After any door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operation at least 5 times:
    1. Close the power window by fully pulling up the power window switch and holding it in the auto up position.
    2. Open the power window by fully pushing down the power window switch.
D-Door Motor

DTC Code

DTC Detection Condition

Trouble Area

B2313

Either condition is met:

  • Power window regulator motor is not initialized.
  • Power window regulator motor malfunctions.

Front power window regulator motor LH
P-Door Motor

DTC Code

DTC Detection Condition

Trouble Area

B2313

Either condition is met:

  • Power window regulator motor is not initialized.
  • Power window regulator motor malfunctions.

Front power window regulator motor RH
RL-Door Motor

DTC Code

DTC Detection Condition

Trouble Area

B2313

Either condition is met:

  • Power window regulator motor is not initialized.
  • Power window regulator motor malfunctions.

Rear power window regulator motor LH
RR-Door Motor

DTC Code

DTC Detection Condition

Trouble Area

B2313

Either condition is met:

  • Power window regulator motor is not initialized.
  • Power window regulator motor malfunctions.

Rear power window regulator motor RH
PROCEDURE

  1. PERFORM INITIALIZATION (APPLICABLE LOCATION)

(a) Initialize the power window regulator motor (See page ).


NEXT

  1. CHECK DTC

(a) Check for DTCs (See page ).


OK:

DTC B2313 is not output

Result

Result

Proceed to

No DTCs output

A

DTC output (Front power window LH)

B

DTC output (Front power window RH)

C

DTC output (Rear power window LH)

D

DTC output (Rear power window RH)

E

A

END (POWER WINDOW CONTROL SYSTEM WAS NOT INITIALIZED)

B

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

C

REPLACE FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

D

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

E

REPLACE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.