Image from Camera for Rear View Monitor is Abnormal

DESCRIPTION

The display signal from the rear television camera assembly transmits to the radio and display receiver assembly.

WIRING DIAGRAM
PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - REAR TELEVISION CAMERA ASSEMBLY)

(a) Disconnect the G50 radio and display receiver assembly connector.

(b) Disconnect the Y2 rear television camera assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance (Check for Open):

Tester Connection	Condition	Specified Condition
G50-11 (CA+) - Y2-6 (CB+)	Always	Below 1 Ω
G50-12 (V+) - Y2-3 (CV+)	Always	Below 1 Ω
G50-23 (CGND) - Y2-5 (CGND)	Always	Below 1 Ω
G50-24 (V-) - Y2-2 (CV-)	Always	Below 1 Ω

Standard Resistance (Check for Short):

Tester Connection	Condition	Specified Condition
G50-11 (CA+) - Body ground	Always	10 kΩ or higher
G50-12 (V+) - Body ground	Always	10 kΩ or higher
G50-23 (CGND) - Body ground	Always	10 kΩ or higher
G50-24 (V-) - Body ground	Always	10 kΩ or higher

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

OK

1. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY

(a) Reconnect the G50 radio and display receiver assembly connector.

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection	Condition	Specified Condition
G50-23 (CGND) - Body ground	Always	Below 1 Ω
G50-24 (V-) - Body ground	Always	Below 1 Ω

(c) Measure the voltage according to the value(s) in the table below.

Standard Voltage:

Tester Connection	Condition	Specified Condition
G50-11 (CA+) - G50-23 (CGND)	Ignition switch ACC	5.5 to 7.05 V

Text in Illustration

*a	Component with harness connected (Radio and Display Receiver Assembly)

NG

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

OK

1. INSPECT REAR TELEVISION CAMERA ASSEMBLY

(a) Reconnect the Y2 rear television camera assembly connector.

(b) Check the waveform of the rear television camera assembly using an oscilloscope.

HINT:

A waterproof connector is used for the rear television camera assembly. Therefore, inspect the waveform at the radio and display receiver assembly with the connector connected.

Text in Illustration

*a	Component with harness connected (Radio and Display Receiver Assembly)	*b	Waveform 1 (under normal conditions)
*c	Waveform 2 (camera lens is covered, blacking out the screen)	*d	Synchronized Signal
*e	Video Waveform	-	-

OK:

Waveform is as shown in the illustration.

Item	Content
Terminal No. (Symbol)	G50-12 (V+) - G50-24 (V-)
Tool Setting	200 mV/DIV., 50 μsec./DIV.
Condition	Ignition switch ON, shift lever in R

HINT:

The video waveform changes according to the image sent by the rear television camera assembly.

OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPLACE REAR TELEVISION CAMERA ASSEMBLY