Installation

1. INSTALL FRONT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

NOTICE:

The regulator arm must be below the intermediate position when installing the power window regulator motor.

(a) Using a T25 "TORX" socket wrench, install the power window regulator motor with the 3 screws. HINT: Tighten the screws in the order shown in the illustration. A new front window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are installed. Torque: 5,4 N·m {55 kgf·cm, 48 in·lbf}

2. INSTALL FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY LH

3. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY LH

4. INSTALL FRONT DOOR SERVICE HOLE COVER LH

5. INSTALL FRONT NO. 1 SPEAKER ASSEMBLY

6. INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP LH

7. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

8. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

9. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

11. INITIALIZE POWER WINDOW CONTROL SYSTEM

(a) Initialize the power window control system (See page ).

12. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).