Personal Light(for Front Door)

1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Apply battery voltage to the connector and check the LED illumination. OK: Measurement Condition Specified Condition Battery positive (+) → Terminal 2 (+B) Battery negative (-) → Terminal 1 (GND) LED illuminates If the result is not as specified, replace the No. 1 interior illumination light assembly. Text in Illustration *a Component without harness connected (No. 1 Interior Illumination Light Assembly)

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Connect the connector.

(b) Attach the claw to install the light.

2. INSTALL FRONT DOOR GLASS WEATHERSTRIP INNER LH

3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL NO. 2 DOOR INSIDE HANDLE BEZEL LH

5. INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH LH

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

2. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

3. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

4. REMOVE FRONT DOOR GLASS WEATHERSTRIP INNER LH

5. REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Using a screwdriver, detach the claw and remove the light. HINT: Tape the screwdriver tip before use. Text in Illustration *1 Protective Tape

(b) Disconnect the connector.