Toyota 4Runner Quiz
Vehicle Interior

Rear Door Courtesy Switch

In this manual: Vehicle Interior
General — 25Audio / Visual / Telematics — 283Brake — 187Drivetrain — 204Power Source / Network — 79Steering — 76Suspension — 130Vehicle Exterior — 391Vehicle Interior — 693
~1min read
Components COMPONENTS ILLUSTRATION
Inspection INSPECTION PROCEDURE

1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

1 - Switch body

Pin not pushed

Below 1 Ω

Pin pushed

10 kΩ or higher

If the result is not as specified, replace the rear door courtesy light switch assembly.

Text in Illustration

*a

Component without harness connected

(Rear Door Courtesy Light Switch Assembly)
Removal REMOVAL CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.
PROCEDURE

1. REMOVE REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Using a T30 "TORX" socket wrench, remove the screw and courtesy light switch.

(b) Disconnect the connector.

Installation INSTALLATION CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH and LH sides.
  • The procedure listed below is for the LH side.
PROCEDURE

1. INSTALL REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY

(a) Connect the connector.

(b) Using a T30 "TORX" socket wrench, install the courtesy light switch with the screw.

Test yourself

A quick Toyota 4Runner quiz: every answer comes with an explanation and a link to the manual page.