Personal Light(for Rear Door)

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. REMOVE REAR DOOR INSIDE HANDLE BEZEL LH

2. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. REMOVE REAR DOOR GLASS WEATHERSTRIP INNER LH

4. REMOVE NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Using a screwdriver, detach the claw and remove the light. HINT: Tape the screwdriver tip before use. Text in Illustration *1 Protective Tape

(b) Disconnect the connector.

1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Apply battery voltage to the connector and check the LED illumination. OK: Measurement Condition Specified Condition Battery positive (+) → Terminal 2 (+B) Battery negative (-) → Terminal 1 (GND) LED illuminates If the result is not as specified, replace the No. 1 interior illumination light assembly. Text in Illustration *a Component without harness connected (No. 1 Interior Illumination Light Assembly)

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.

1. INSTALL NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY

(a) Connect the connector.

(b) Attach the claw to install the light.

2. INSTALL REAR DOOR GLASS WEATHERSTRIP INNER LH

3. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

4. INSTALL REAR DOOR INSIDE HANDLE BEZEL LH