Rear Combination Light Assembly

Components COMPONENTS ILLUSTRATION
Removal REMOVAL CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT LENS AND BODY LH

(a) Remove the cover.

(b) Remove the 2 nuts.

(c) Detach the 2 clips and 3 guides to remove the rear combination light lens and body LH.

(d) Disconnect the connector.

Disassembly DISASSEMBLY CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure listed below is for the LH side.

PROCEDURE

1. REMOVE REAR COMBINATION LIGHT GASKET LH

(a) Remove the rear combination light gasket LH.

2. REMOVE REAR TURN SIGNAL LIGHT BULB

(a) Turn the socket in the direction indicated by the arrow to remove it.

(b) Remove the rear turn signal light bulb.

3. REMOVE BACK UP LIGHT BULB

(a) Turn the socket in the direction indicated by the arrow and remove it.

(b) Remove the back up light bulb.

4. REMOVE REAR COMBINATION LIGHT SOCKET AND WIRE LH

(a) Remove the screw.

(b) Detach the 3 clamps.

(c) Disconnect the connector and remove the rear combination light socket and wire LH.

Reassembly REASSEMBLY CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT SOCKET AND WIRE LH

(a) Connect the connector.

(b) Attach the 3 clamps to install the rear combination light socket and wire LH.

(c) Install the screw.

2. INSTALL BACK UP LIGHT BULB

(a) Install the back up light bulb.

(b) Turn the socket in the direction indicated by the arrow to install it.

3. INSTALL REAR TURN SIGNAL LIGHT BULB

(a) Install the rear turn signal light bulb.

(b) Turn the socket in the direction indicated by the arrow to install it.

4. INSTALL REAR COMBINATION LIGHT GASKET LH

(a) Install a new rear combination light gasket LH.

Installation INSTALLATION CAUTION / NOTICE / HINT

HINT:

• Use the same procedure for both the RH and LH sides.
• The procedure listed below is for the LH side.

PROCEDURE

1. INSTALL REAR COMBINATION LIGHT LENS AND BODY LH

(a) Attach the 2 clips and 3 guides to install the rear combination light lens and body LH.

(b) Install the 2 nuts.

Torque:

4,5 N·m {46 kgf·cm, 40 in·lbf}

(c) Connect the connector.

(d) Install the cover.