Removal

REMOVAL PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE ASSIST STRAP HOLE COVER

3. REMOVE ASSIST STRAP ASSEMBLY

4. REMOVE BACK DOOR TRIM PANEL ASSEMBLY

5. REMOVE REAR NO. 2 SPEAKER ASSEMBLY

6. REMOVE MULTIPLEX NETWORK DOOR ECU

7. REMOVE NO. 2 BACK DOOR SERVICE HOLE COVER

8. REMOVE BACK DOOR SERVICE HOLE COVER LH

9. REMOVE BACK DOOR SERVICE HOLE COVER RH

10. REMOVE BACK DOOR OUTSIDE MOULDING LH

11. REMOVE BACK DOOR OUTSIDE MOULDING RH

HINT:

Use the same procedure described for the LH side.

12. REMOVE REAR NO. 1 SPOILER COVER

13. REMOVE REAR SPOILER SUB-ASSEMBLY

14. REMOVE REAR WIPER ARM

15. REMOVE REAR WIPER MOTOR AND BRACKET ASSEMBLY

16. REMOVE NO. 1 BACK WINDOW WIPER MOTOR BRACKET

17. REMOVE BACK DOOR GLASS RUN

18. REMOVE BACK DOOR GLASS

19. REMOVE OUTER BACK DOOR GLASS WEATHERSTRIP ASSEMBLY

(a) Put protective tape around the outer back door glass weatherstrip.

Text in Illustration

*1	Protective Tape

(b) Detach the 8 claws and remove the outer back door glass weatherstrip.