Removal

HINT:

• Use the same procedure for the RH and LH sides.
• The procedure listed below is for the LH side.
• When removing the window frame moulding, heat the vehicle body and window frame moulding using a heat light.

  Standard:

  Item	Temperature
  Vehicle Body	40 to 60 °C
  Window Frame Moulding	20 to 30 °C

NOTICE:

Do not heat the vehicle body or window frame moulding excessively.

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

3. REMOVE NO. 2 DOOR INSIDE HANDLE BEZEL LH

4. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

5. REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

6. REMOVE FRONT DOOR SERVICE HOLE COVER LH

7. REMOVE OUTER REAR VIEW MIRROR ASSEMBLY LH

8. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

9. REMOVE FRONT DOOR GLASS RUN LH

10. REMOVE FRONT DOOR BELT MOULDING LH

11. REMOVE FRONT DOOR WEATHERSTRIP LH

(a) Detach the 3 clips and remove the upper part of the front door weatherstrip so that the moulding can be removed.

12. REMOVE FRONT DOOR REAR WINDOW FRAME MOULDING LH

(a) Remove the door window frame moulding clip.

(b) Put protective tape around the front door rear window frame moulding. Text in Illustration *1 Protective Tape *2 Double-sided Tape *3 Moulding Remover

(c) Using a moulding remover, detach the clip and remove the double-sided tape to remove the front door rear window frame moulding.