Steering Angle Sensor

1. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE STEERING WHEEL ASSEMBLY

(a) Remove the steering wheel assembly (See page ).

4. REMOVE LOWER STEERING COLUMN COVER

5. REMOVE UPPER STEERING COLUMN COVER

6. REMOVE SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Remove the spiral cable with steering angle sensor (See page ).

NOTICE:

• Do not replace the spiral cable with the battery connected and the ignition switch ON.
• Do not rotate the spiral cable with the battery connected and the ignition switch ON.
• Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
• Do not remove the steering angle sensor from the spiral cable.

1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR

(a) Install the spiral cable with steering angle sensor (See page ).

NOTICE:

• Do not replace the spiral cable with the battery connected and the ignition switch ON.
• Do not rotate the spiral cable with the battery connected and the ignition switch ON.
• Make sure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
• Do not remove the steering angle sensor from the spiral cable.

2. INSTALL UPPER STEERING COLUMN COVER

3. INSTALL LOWER STEERING COLUMN COVER

4. ADJUST SPIRAL CABLE

5. INSTALL STEERING WHEEL ASSEMBLY

(a) Install the steering wheel assembly (See page ).

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

7. CHECK SRS WARNING LIGHT

(a) Check the SRS warning light (See page ).