2gr-fks Battery
Components
COMPONENTS
ILLUSTRATION
*1 |
BATTERY |
*2 |
NEGATIVE BATTERY TERMINAL |
*3 |
POSITIVE BATTERY TERMINAL |
*4 |
NO. 2 BATTERY CLAMP |
*5 |
BATTERY TERMINAL CAP |
- |
- |
![]() |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
Installation
INSTALLATION
PROCEDURE
1. INSTALL BATTERY
(a) Install the battery to the vehicle.
(b) Install the No. 2 battery clamp to the battery clamp sub-assembly with the bolt.
![]() |
Remove in this Direction |
Torque:
18,5 N·m {189 kgf·cm, 14 ft·lbf}
(c) Connect the cable to the positive (+) battery terminal and tighten the nut.
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
(d) Engage the 2 claws to install the battery terminal cap to the positive (+) battery terminal.
2. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
(a) Connect the cable to the negative (-) battery terminal and tighten the nut.
Torque:
5,4 N·m {55 kgf·cm, 48 in·lbf}
NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced battery removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| *: When performing learning using the Techstream. Click here |
|||
Battery terminal is disconnected/reconnected |
Perform steering sensor zero point calibration |
Lane departure alert system (w/ Steering Control) |
|
Pre-collision system |
|||
Intelligent clearance sonar system* |
|||
Lighting System (for Gasoline Model with Cornering Light) |
|||
Memorize steering angle neutral point |
Parking assist monitor system |
||
Panoramic view monitor system |
|||
PROCEDURE
1. PRECAUTION
NOTICE:
- After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here

- When replacing the battery, use a new battery of the same dimensions with a capacity of 70 Ah or more at a 20-hour rate.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
(a) Loosen the nut, and disconnect the cable from the negative (-) battery terminal. NOTICE: When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here |
![]() |
3. REMOVE BATTERY
(a) Disengage the 2 claws and remove the battery terminal cap from the positive (+) battery terminal in the order shown in the illustration.
*a |
Side View of Claws |
![]() |
Push Battery Terminal Cap Here |
![]() |
Push |
(b) Loosen the nut and disconnect the cable from the positive (+) battery terminal. |
![]() |
(c) Remove the bolt and No. 2 battery clamp from the battery clamp sub-assembly.
![]() |
Remove in this Direction |
(d) Remove the battery from the vehicle.






