2gr-fks Spark Plug
Components
COMPONENTS
ILLUSTRATION
*1 |
IGNITION COIL ASSEMBLY |
*2 |
SPARK PLUG |
*3 |
V-BANK COVER SUB-ASSEMBLY |
*4 |
VACUUM HOSE |
![]() |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
Installation
INSTALLATION
PROCEDURE
1. INSTALL SPARK PLUG
HINT:
Perform "Inspection After Repair" after replacing a spark plug.
Click here ![]()
(a) Install the 6 spark plugs to the cylinder head sub-assembly and cylinder head LH.
Torque:
18 N·m {184 kgf·cm, 13 ft·lbf}
NOTICE:
If a spark plug has been struck or dropped, replace it.
HINT:
Install the same parts to their original positions.
2. INSTALL IGNITION COIL ASSEMBLY
Click here ![]()
3. INSTALL V-BANK COVER SUB-ASSEMBLY
Click here ![]()
4. PERFORM INITIALIZATION
(a) Perform "Inspection After Repair" after replacing an ignition coil assembly or spark plug.
Click here ![]()
Removal
REMOVAL
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during spark plug removal/installation are shown below.
Necessary Procedures After Parts Removed/Installed/ReplacedReplaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
|
Inspection after repair |
|
PROCEDURE
1. REMOVE V-BANK COVER SUB-ASSEMBLY
Click here ![]()
2. REMOVE IGNITION COIL ASSEMBLY
Click here ![]()
3. REMOVE SPARK PLUG
(a) Remove the 6 spark plugs from the cylinder head sub-assembly and cylinder head LH. NOTICE: If a spark plug has been struck or dropped, replace it. HINT: Arrange the removed parts in the correct order. |
![]() |


