Windows

Rear Power Window Switch

~2min read

Components

COMPONENTS

ILLUSTRATION

*1

REAR DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY WITH POWER WINDOW SWITCH ASSEMBLY

*2

REAR POWER WINDOW SWITCH ASSEMBLY

*3

REAR DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY

-

-

Inspection

INSPECTION

PROCEDURE

1. INSPECT REAR POWER WINDOW SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) shown in the table below.

Standard resistance:

Tester Connection

Condition

Specified Condition

5 (UP) - 7 (GND)

Auto close or close position

Less than 100 Ω

4 (DOWN) - 7 (GND)

Auto open or open position

Less than 100 Ω

8 (AUTO) - 7 (GND)

Auto close or auto open position

Less than 100 Ω

5 (UP) - 7 (GND)

OFF

10 kΩ minimum

4 (DOWN) - 7 (GND)

OFF

10 kΩ minimum

8 (AUTO) - 7 (GND)

OFF

10 kΩ minimum

If the result is not as specified, replace the rear power window switch assembly.

*a

Component without wire harness connected

(rear power window switch assembly)

(b) Check that the LED lights up.

(1) Apply battery voltage to the power window switch assembly and check that the LED lights up.

OK:

Battery connection

Specified Condition

Battery positive (+) → 3 (ILL+)

Battery negative (-) → 1 (ILL-)

LED lights up

If the result is not as specified, replace the rear power window switch assembly.

Removal

REMOVAL

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. REMOVE REAR POWER WINDOW SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY

Click here

2. REMOVE REAR POWER WINDOW SWITCH ASSEMBLY

(a) Release the clips to remove the rear power window switch assembly.

Installation

INSTALLATION

PRECAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side as for the LH side.
  • The procedure described below applies to the LH side.

PROCEDURE

1. INSTALL REAR POWER WINDOW SWITCH ASSEMBLY

(a) Engage the clips to install the rear power window switch assembly.

2. INSTALL REAR POWER WINDOW SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE UPPER PANEL SUB-ASSEMBLY

Click here