Windows

Rear Window Defogger Grid

~3min read

Inspection On Vehicle

INSPECTION ON VEHICLE

PROCEDURE

1. INSPECT BACK DOOR GLASS (DEFOGGER GRID)

NOTICE:

  • When cleaning the glass, wipe along the grid lines with a soft, dry cloth. Be careful not to damage the defogger grid.
  • Do not use detergents or glass cleaners containing abrasive substances.
  • When measuring voltage, wrap the negative (-) tester probe tip with tin foil and press it against the wire with your fingers, as shown in the illustration.

*a

Defogger grid

*b

Tin foil

*c

Tester probe

(a) Turn the ignition switch to ON.

(b) Set the rear window defogger switch to ON.

*a

Center

(c) Measure the voltage at the center of each defogger grid line, as shown in the illustration.

Standard voltage:

Voltage

Specified Condition

About 5 V

Wire is not broken

About 10 or 0 V

Wire is broken

*a

Ground side

*b

Piece of foil

*c

About 10 V

*d

0 V

*e

Cut wire

*f

Battery side

HINT:

If the voltage is about 10 V, the malfunction may be located between the center of the wire and its battery side end. If there is no voltage, the malfunction may be located between the center of the wire and its ground side end.

(d) Touch the positive (+) voltmeter probe to the defogger wire on the battery side.

(e) Touch the negative (-) voltmeter probe with the piece of foil to the wire on the ground side.

(f) Slide the positive (+) probe from the battery side toward the ground side.

(g) The break in the defogger wire is located where the voltage changes from about 10 V to 0 V.

HINT:

If there is no break in the defogger wire, the voltmeter reads 0 V at the positive (+) end of the defogger wire, and the value gradually increases to about 12 V as the tester probe moves toward the other end.

Precautions

PRECAUTION

IGNITION SWITCH TERMS

(a) The type of ignition switch used varies depending on vehicle specifications. The terms listed in the table below are used in this section.

Term

Ignition Switch (Position)

Engine Switch (Condition)

Ignition Switch in OFF position

LOCK

OFF (Locked)

Ignition Switch in ACC position

ACC

ON (ACC)

Ignition Switch in ON position

ON

ON (IG)

Starting the engine

START

ON (Starting)

Repair

REPAIR

PROCEDURE

1. REPAIR BACK DOOR GLASS

*1

Cut wire

*2

Protective tape

*a

Area to be repaired

(a) Clean the ends of the broken wire with grease, wax and silicone remover.

(b) Apply protective tape to both sides of the wire.

(c) Mix the repair material thoroughly.

(d) Apply a small amount of material to the wire using a fine brush.

*1

Fine brush

*a

Area to be repaired

(e) After a few minutes, remove the protective tape.

NOTICE:

Wait at least 24 hours before performing any further repair on the defogger wire.